E-mail Setup Instructions

Microsoft™ Outlook 2000

You may wish to print out these directions for future reference.

• Start Here
• Load Outlook
• Click on Tools | Accounts...
• Click Add | Mail...
• Type in a Display name as you would like to see it (for example: John Smith)
• Click Next
• Type in your new E-mail address (Example: john@yourdomain.com)
• Click Next
• Server Information
• Choose POP3 as your incoming mail server
• Type in your Incoming POP server: mail.yourdomain.com
• Type in your Outgoing SMTP server: mail.yourdomain.com
  *NOTE: Your ISP may require you to use their SMTP server. If you are not sure, try this setting first and if it does not allow you to send e-mail, contact your ISP for their required settings.
• Click Next
• Account Information
• Type in your Account name (Example: john@yourdomain.com)
• Type in your Password (Example: *****)
• Check to Remember password, if desired
• Click Next
• Connection Type
• Select either of the following 2 options:
  • Connect using my phone line
    With this option, when you load Outlook, your computer will attempt to dial whenever a connection is not present.
  • I will establish my Internet connection manually
    With this option, Outlook will assume you have already established a connection and not initiate the dial-up modem.
• Click Next
• If you choose Connect using my phone line, then:
     Select Use an existing dial-up connection
     Choose your preferred provider from your list of dial-up connections.
     Click Finish
  
• If you choose I will establish my Internet connection manually, then:
     Click Finish

That's it, you're all finished. See... that wasn't too hard, now was it?